Shure SM35-XLR - Wailian Electronics Pte Ltd

Products

Shure SM35-XLR Performance Headset Condenser Microphone with In-Line XLR Preamp

($269.00 incl GST)

with RPM400TQG in-line XLR preamp, operates by phantom power

Product is unavailable. Notify me when product is available

The Shure SM35 is a headworn electret condenser microphone, intended for use with a wireless bodypack transmitter in live stage performances.

The Shure SM35-XLR includes an In-Line RPM400TQG preamp for use in standard wired (XLR) applications.

FEATURES

Wireframe headset fits securely and comfortably for active performers and multi-instrumentalists
Tight, unidirectional cardioid polar pattern rejects signal bleed and feedback for use on loud stages and behind floor monitors
Flexible gooseneck design allows for optimized placement that further improves source isolation
Lightweight and low-profile form enables comfortable, long-wearing use
TA4F (TQG) connector is compatible with any Shure wireless bodypack
Locking snap-fit windscreens tame plosives, breath, and wind noise for clean and intelligible sound
Tailored frequency response refined for clear, crisp vocal reproduction
Legendary Shure precision engineering for durability and performance

Type: Electret Condenser
Frequency Response: 40 Hz to 20,000 Hz
Polar Pattern: Unidirectional (Cardioid)
Output Impedance: 100 Ω, @ 1 kHz
Sensitivity: -57.8 dBV/Pa, @ 1 kHz, 1000 Ω load
Signal-To-Noise Ratio ^[1]
- 59.2 dB, @ 1 kHz, 1000 Ω load
Maximum SPL ^[1]
- 151.3 dB, 1000 Ω load, @ 1 kHz, 1% THD
Dynamic Range ^[1]
- 116.5 dB, @ 1 kHz, 1000 Ω load
Self Noise ^[1]
- 34.8 dB SPL-A, 1000 Ω load
Power Requirements:
- TA4F: +5 V DC (nominal), 10 V maximum (DC bias)
- XLR Connector: 12 to 52 V DC, phantom power
Polarity:
- TA4F: Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1
- XLR Connector: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3
Cable: 1.1m (45in.)
Connector: TA4F or XLR
Weight: 72 g (2.53 oz.)
^[1]Measurements taken using RPM400 preamp
*All specifications measured with a 48 Vdc phantom power supply. The microphone operates at lower voltages, but with slightly decreased headroom and sensitivity.